O Series: RGB for Over-Drive

    Over-Drive techniques used to compensate the LCD reaction speed, which was not fast enough in high refreshing frame rate. Over drive provides higher level of voltage than the usual when the pixel’s bright level gap between current and previous frame is large. Previous frame should be stored in memory to be the reference. Memory cost and bandwidth is considered from system’s point of view.

    Reference frame data of over drive do not necessarily visual lossless. Higher lossy level may be acceptable. Therefore, FPGA for moving picture quality check is needed when adopting this IP.  TITC proposed several types of compression, from small block 2x2 to 4x4 to slice-based, from RGB to Y-only, from compression ratio 2 to 12. Customization is possible.

系統圖-OD.png

◇◆TITC O-Series IP

表格-OD.png